Yes. Our planter box factory provides both installation instructions and an anchoring template for securing planters to a concrete pad. The standard package includes a step-by-step PDF/manual, a scale layout template, a hardware schedule, anchor placement marks, base-rail details, leveling and shimming guidance, drainage notes, and inspection checkpoints. For custom planter sizes, we can issue a project-specific template and drawing set so the installer can mark anchor points accurately before drilling.

The template is not a substitute for site verification. Before anchoring, confirm that the concrete pad is fully cured, clean, level, and structurally suitable. Check slab thickness, compressive strength, edge distance, and embedment depth. In high-wind, seismic, or freeze-thaw areas, local codes or a licensed engineer should approve the final anchor type and spacing. We recommend wedge anchors, sleeve anchors, or adhesive anchors in stainless or hot-dip galvanized finishes, depending on exposure. Avoid cutting rebar; use a hammer drill, vacuum dust from holes, and follow the specified drill bit size and torque.

Planters should be anchored through internal base rails or reinforced brackets rather than through the wall alone. Use washers and, where required, sealing washers to protect the finish and limit water intrusion. Keep weep holes and drainage paths clear, and do not over-tighten anchors. The installation guide explains how to level the unit with shims, set anchor locations, verify alignment, and complete a final pull/torque check. Our factory also offers remote support, replacement hardware lists, and optional custom engineering for non-standard projects.