We had a bad experience with a previous outdoor bench factory where the wood splintered—do you use finger-jointed or solid lumber?

2026-11-12 Visits: Abstract: For exposed and load-bearing outdoor bench parts, we use solid kiln-dried hardwood—not finger-jointed lumber—to reduce splintering and improve weather durability.

Thank you for asking this directly. The short answer is that for outdoor benches, we use solid lumber—not finger-jointed lumber—for all exposed, visible, and load-bearing parts. That includes seat slats, backrests, arms, legs, and frames. We do not rely on finger-jointed boards to hold the bench together or to create the surfaces customers touch and see every day. The splintering you experienced is often linked to weak glue lines, mismatched grain, short offcuts, or poor moisture control in finger-jointed material, especially when it is exposed to sun, rain, and temperature swings.

Our material standard starts with kiln-dried hardwood selected for outdoor use. We check moisture content before machining, cut with grain direction in mind, and round or chamfer every exposed edge. Sanding is done in stages because a smooth, sealed edge is one of the simplest ways to reduce splintering and rough spots. We then apply an exterior-grade finish and use corrosion-resistant hardware so the bench performs as a system, not just a collection of boards. Solid lumber has continuous grain, so it weathers more predictably and can be sanded or refinished later. If a small surface fiber lifts after years of exposure, it can usually be maintained rather than replaced.

If a project has a tight budget, some factories switch to finger-jointed lumber in visible slats. We do not take that shortcut for outdoor benches. We may consider finger-jointed material only for concealed, non-structural parts if a customer specifically requests it, and only with exterior-grade adhesive and proper treatment. It is never our standard for seat, back, arm, or leg components. Before shipping, we inspect for glue line gaps, raised grain, sharp edges, and loose knots. We can also provide material samples and finish swatches so you can compare the surface before placing a production order. Our goal is a bench that feels smooth in use and holds up through real outdoor conditions—not one that looks acceptable only on the first day.

Search Tags:
Product Center

Leave Your Message


Leave a message