Yes. Our outdoor bench factory offers both adjustable feet and leveling glides, and we often combine them with custom leg or mounting solutions when the ground is truly uneven. Uneven terrain is not treated as a one-size-fits-all problem; it is a design variable that affects stability, comfort, drainage, and safety.
For most surface-mounted outdoor benches, we recommend adjustable feet with threaded stems and lock nuts. These allow installers to raise or lower each corner independently, usually within a range of 15 mm to 50 mm, with custom ranges available for more demanding sites. The foot pad can be nylon, rubber, EPDM, or stainless steel, depending on whether the bench will sit on concrete, pavers, decking, or stone. A lock nut holds the setting after adjustment, so the bench does not drift over time.
Leveling glides are another option, especially for lighter benches or installations where fine adjustment and surface protection matter most. Many of our glides have swivel bases, which let the foot sit flat even when the bench leg is slightly angled. They are ideal for decks, balconies, and paved areas because non-marking pads reduce scratching and noise.
When the slope is too steep for standard feet or glides, we fabricate custom solutions. This may include legs cut to different lengths, angled leg bottoms, slotted anchor plates, or concealed leveling brackets. Slotted mounting plates are particularly useful because they allow lateral adjustment over anchor bolts before final tightening. For permanent installations, we can also supply shim kits, drainage spacers, and heavy-duty anchor plates.
Soft ground is handled differently from hard ground. On soil, gravel, or sand, we may use ground spikes, concrete footings, or wider base plates to spread the load. On concrete or pavers, bolt-down feet with corrosion-resistant hardware keep the bench secure. In every case, we keep the frame slightly raised so water can drain and air can circulate, which helps extend the bench’s service life.
All leveling hardware is selected for outdoor durability. Common materials include stainless steel, hot-dip galvanized steel, and powder-coated components. Rubber and EPDM pads are UV-resistant and designed to protect both the bench finish and the mounting surface.
Our factory also provides installation guidance. We recommend adjusting the feet or glides gradually, checking the seat with a spirit level, and locking each nut once the bench is stable. Thread engagement should remain sufficient, and installers should avoid overextending the levelers, as that can reduce strength. For large projects, we can supply CAD drawings, load ratings, and site-specific recommendations.
So, to answer directly: yes, we offer adjustable feet and leveling glides. The best solution depends on your bench model, surface type, slope, and load requirements. If you share your site conditions, our outdoor bench factory can specify the right leveling system or custom leg design for a safe, stable, and professional installation.
