Thank you for choosing our trash can factory. To clean your bin without harming the finish, first identify the material: powder-coated steel, brushed stainless steel, galvanized metal, or molded plastic. The safest rule is to use the mildest cleaner that works and to avoid abrasive pads, harsh solvents, and prolonged moisture. Start by removing the liner and emptying loose debris. Rinse with warm, not hot, water to soften residue. Mix a few drops of mild dish soap into a bucket of warm water. Dip a soft microfiber cloth or non-scratch sponge into the solution and wipe the lid, body, and base. For crevices around the rim, handle, or pedal, use a soft-bristle brush such as an old toothbrush. Never use steel wool, scouring pads, wire brushes, or abrasive powders, because they can scratch the coating, dull stainless steel, or remove printed logos. For powder-coated finishes, avoid alcohol, acetone, paint thinner, and strong degreasers, which can cloud or soften the coating. If sticky residue remains, use a little baking soda on a damp cloth, rub gently, then rinse thoroughly. For brushed stainless steel, always wipe in the direction of the grain. A dedicated stainless steel cleaner or a tiny amount of mineral oil on a microfiber cloth can restore shine. Never use chlorine bleach or ammonia on stainless steel, because they can pit the surface. If disinfection is needed, use 70% isopropyl alcohol on stainless steel and most powder-coated finishes, then rinse. For bleach-safe plastic bins, a 1:10 dilution of household bleach can be used, but leave it for no more than one minute, then rinse and dry. For galvanized metal, keep water contact brief. Wash with mild soap, rinse quickly, and dry immediately to reduce white rust. For plastic cans, avoid solvents and abrasive cleansers; a paste of baking soda and water works well for odors and stains. After washing, rinse with clean water and dry every surface with a clean cloth. Let the can air-dry completely before replacing the liner. Moisture trapped under a liner can cause odors, mold, or rust. To deodorize, sprinkle baking soda inside, leave it overnight, then vacuum or rinse. For ongoing care, clean weekly, wipe spills immediately, and use liners that fit properly. If your bin has a pedal, wheels, or electronic sensor, do not submerge it; wipe those parts with a damp cloth only. Test any new cleaner on a hidden area first. Following these steps will keep your trash can from our factory looking clean and finished for years.